NOTE* those with Tyga or Yoshi tag lighting you will need to keep the yellow wire going back to the tag light attached to the factory plug. These tag lights are AC powered only.
As close to plug n play as it can get with the Honda Grom. "converting your headlights to DC?" This is the perfect mod to do this and not have to add any wiring or cut any wires. This will make your headlights stay on constant. no more dimming lights when you are at a stop light. When doing this mod you will lose the "high beam" display from the cluster. The high/low beam will still function but it will not light up on the cluster when the high beam is on.
The high beam indicator can be made to work properly for $20 in the add-on section. We need your cluster sent to us to make this correction.
1: Remove Yellow connection from socket located behind the right fairing just behind the rear brake reservoir.
2: Insert the white wire with spade connection on it into the yellow plug and cover with heat shrink to protect from shorting.
3: Remove the 10mm bolt from grounding lug at the base of the fuel tank and install eyelit and reinstall 10mm bolt
4: Using the "NEW T tap connection" to connect other end of the jumper wire to the "Black" wire on the motorcycle side of the 3 pin connection that the taillight connects to.
To connect remove the grey/black end cap and place the black wire in the "U" channel and then tighten down the connection. The point inside will pierce the wire and make a connection. No cutting or tape needed.
The picture below shows which wire you need to connect to if you cannot see the black wire on the motorcycle side of the plug. If you view the orientation of the plug you will tap into the blue wire on this taillight shown.
Multiple time delays to choose from using the dip switches.
0-38 sec delay.
Delay is calculated as SW1 * (SW2 + SW3 + SW4)
Some possible delays are (seconds):